石油管材及裝備材料服役行為與結構安全國家重點實驗室科研成果匯編(2020年)
定 價:200 元
- 作者:中國石油集團石油管工程技術研究院等編
- 出版時間:2021/8/1
- ISBN:9787518347919
- 出 版 社:石油工業出版社
- 中圖法分類:TE973-53
- 頁碼:
- 紙張:膠版紙
- 版次:
- 開本:16開
本書匯編了中國石油集團石油管工程技術研究院、石油管材及裝備材料服役行為與結構安全國家重點實驗室、中國石油集團石油管工程重點實驗室和陜西省石油管材及裝備材料服役行為與結構安全重點實驗室在□0□0年正式發表在國際國內刊物上的論文和□0□0年授權專利及省部級以上獲獎成果,反映了近幾年石油管工程的科研成果及進展。內容涉及輸送管與管線安全評價、油井管與管柱失效預防、腐蝕防護與非金屬材料等方面。
本書可供從事石油管工程的技術人員和石油院校相關專業師生參考。
□□篇 論文篇
一、輸送管與管線安全評價
輸送管產品開發與工程應用技術支撐體系
中國X80管線鋼和鋼管研發應用進展及展望
大應□管線鋼和鋼管的關鍵技術進展及展望
3 16L襯里復合管道主要失效形式及其完整性檢測技術研究
Constitutive Equation for Describing True Stress-Strain Curves over a Large Range of Strain□<□r> A Review of Dynamic Muhiaxial Experimental Technique□<□r> Fatigue Failure Analysis of Dented Pipeline and Simulation Calculation
Failure Analysis on Tee Pipe of Duplex Stainless in an Oilfield
Cracking Analysis of a Newly Built Gas Transmission Steel Pipe
Microstructure and Impact Toughness of X70-L□45 Butt Girth Weld in Natural Gas Station
Dynamic Impact Damage of Oil and Gas Pipeline□<□r> X70管道自保護藥芯焊絲環焊接頭力學性能及影響因素
埋地管道泄漏數值模擬分析
二、油井管與管柱失效預防
復雜工況油套管柱失效控制與完整性技術研究進展及展望
復雜壓裂頁巖氣井套管□形機制及控制方法
Investigation on Impact Absorbed Energy Index of Drill Pipe
Aging Treatment Effect on Microstructure and Mechanical Properties of Ti-5A1-3V-1.5 Mo-□Zr Titanium Alloy Drill Pipe
Tribological Properties of Ni/Cu/Ni Coating on the Ti-6Al-4V Alloy after Annealing at Various Temperature□<□r> Application Analysis of Epoxy-Coated Tubing in an Oilfield
Failure Analysis of Casing Dropping in Shale Oil Well during Large Scale Volume Fracturing
Numerical Analysis of Casing Deformation under Cluster Well Spatial Fracturing
Fracture Failure Analysis of C110 Oil Tube in a Western Oil Field
石油管用Ti-6A1-4V-0.1Ru鈦合金高溫流□行為及預測模型研究
油氣開采用鈦合金石油管材料耐腐蝕性能研究
鈦合金油套管抗擠毀性能計算與實驗
三、腐蝕防護與非金屬材料
Facile Fabrication of Sn0□ Modified Ti0□ Nanorods Film for Efficient Photocathodic Protection of 304 Stainless Steel under Simulated Solar Light
Effect of C0□/H□S and Applied Stress on Corrosion Behavior of 15Cr Tubing in Oil Field Environment
Corrosion Behavior of Cr-Bearing Steels in C0□-0□-H□0 Multi-Thermal-Fluid Environment
Corrosion Behavior of Reduced-Graphene-Oxide-Modified Epoxy Coatings on N80 Steel in 10.0 wt%NaCl Solution
Experimental and Simulation Investigation on Failure Mechanism of a Polyethylene Elbow Liner Used in an Oilfield Environment
Failure Analysis on the Oxygen Corrosion of the Perforated Screens Used in a Gas Injection Huff and Puff Well
Investigation on Leakage Cause of Oil Pipeline in the West Oilfield of China
Comparative Study on Hydrogen Embritdement Susceptibility in Heat-Affected Zone of TP3□1 Stainless Steel
External Stress Corrosion Cracking Risk Factors of High Grade Pipeline Steel
Analysis of Corrosion Behavior on External Surface of 11OS Tubing
Failure Analysis and Solution to Bimetallic Lined Pipe
外加電位對X80管線鋼在輪南土壤模擬溶液中應力腐蝕行為的影響
頁巖氣輸送用轉角彎頭內腐蝕減薄原因分析
16Mn管線鋼的焊縫表面沖蝕機理研究
酸洗鈍化對316L/IAl5雙金屬機械復合管環焊縫耐蝕性的影響
干濕交替砂土環境下X80管線鋼的腐蝕行為研究
一種乙烯裂解爐管高溫?fù)p傷評估的新方法
煉化企業常壓塔頂露點溫度計算及緩蝕劑性能研究
連續纖維復合材料環形試樣蠕□行為研究
非金屬智能連續管拉伸層力學特性研究
四、其他
A Strain Rate Dependent Fracture Model of 7050 Aluminum Alloy
Effects of Pre-Oxidation on the Corrosion Behavior of Pure Ti under Coexistence of Solid NaCl Deposit and Humid Oxygen at 600℃: the Diffusion of Chlorine
Failure Analysis of Crankshaft of Fracturing Pump
Failure Analysis of a Sucker Rod Fracture in an Oilfield
Stress Analysis of Large Crude Oil Storage Tank Subjected to Harmonic Settlement
Study on Remaining Oil Distribution of Single Sand Body in Yan 10 Reservoir in Zhenbei Area,Ordos Basin
第二篇 成果篇
一、省部級科技獎勵
1.OD14□□mm X80管線鋼管研制及應用技術
□.復雜工況油氣井管柱腐蝕控制技術及工程應用
3.西部油氣田集輸管線內腐蝕控制技術及